Интерфейсный модуль Juniper MIC-3D-1OC192-XFP

Software release

• Junos OS Release 12.2 and later

For information on which MPCs support this MIC, see MIC/MPC Compatibility. For information on which MICs are supported on MX Series routers, see MICs Supported by MX Series Routers.

Description

• One OC192 port
• Clear channel functionality
• Power requirement: 4.25 A @ 9 V (38.25 W)
• Weight: 1.34 lb (0.61 kg)
• Model number: MIC-3D-1OC192-XFP

Hardware features

• Maximum transmission units (MTUs) of up to 9192 bytes
• MIC bandwidth of up to 10 Gbps

Software features

• SONET/SDH framing
• Multiprotocol Label Switching (MPLS) fast reroute
• Ingress behavior aggregate (BA) classification
• Internal and loop clocking
• Encapsulations:
  • MPLS fast reroute
  • MPLS CCC (circuit cross-connection)
  • MPLS TCC (translational cross-connection)
  • Cisco High-Level Data Link Control (cHDLC)
  • Cisco HDLC CCC
  • Cisco HDLC TCC
  • Point-to-Point Protocol (PPP)
  • PPP for CCC
  • PPP for TCC
  • Flexible Frame Relay
  • Frame Relay
  • Frame Relay for CCC
  • Frame Relay for TCC
  • PPP over Frame Relay
• Note: Ethernet over Frame Relay is not supported.

Cables and connectors

• SONET/SDH OC192/STM64 XFP transceivers:
  • Short reach (SR-1) (model number: XFP-10G-L-OC192-SR1)
  • Intermediate reach (IR-1) (model number: XFP-10G-E-OC192-IR2)
  • Long reach (LR-1) (model number: XFP-10G-Z-OC192-LR2)
• Optical interface specifications—see SONET/SDH OC192/STM64 Optical Interface Specifications

Note: To extend the life of the laser, when a MIC is not being actively used with any valid links, take the MIC offline until you are ready to establish a link to another device. For information about taking a MIC offline, see the request chassis pic offline command in the CLI Explorer.

LEDs

OK/FAIL LED, one bicolor:

• Green—MIC is functioning normally
• Red—MIC has failed

LINK LED, one tricolor per port:

• Off—Not enabled
• Green—Online with no alarms or failures
• Yellow—Online with alarms for remote failures
• Red—Active with a local alarm; router has detected a failure

Alarms, errors, and events

SONET alarms:

• Loss of light (LOL)
• Phase lock loop (PLL)
• Loss of signal (LOS)
• Loss of frame (LOF)
• Severely errored frame (SEF)
• Alarm indicator signal–line (AIS-L)
• Alarm indicator signal–path (AIS-P)
• Remote defect indicator–line (RDI-L)
• Remote defect indicator–path (RDI-P)
• Loss of pointer–path (LOP-P)
• Bit error rate–signal degrade (BERR-SD)
• Bit error rate–signal fail (BERR-SF)
• Payload label mismatch–Path (PLM-P)
• Unequipped–path (UNEQ-P)
• Remote error indicator–path (REI-P)

SDH alarms:

• Loss of light (LOL)
• Phase lock loop (PLL)
• Loss of frame (LOF)
• Loss of signal (LOS)
• Severely errored frame (SEF)
• Multiplex-section alarm indicator signal (MS-AIS)
• Higher order path–alarm indication signal (HP-AIS)
• Loss of pointer (LOP)
• Bit error rate–signal degrade (BER-SD)
• Bit error rate–signal fail (BER-SF)
• Multiplex section–far end receive failure (MS-FERF)
• Higher order path—far-end receive failure (HP-FERF)
• Higher order path—payload label mismatch (HP-PLM)
• Remote error indicator (REI)
• Unequipped (UNEQ)